6 7
2) Press (either short for incremental advance or long for rapid
advance) the T2 button to set the desired hour for your time zone.
Please take note of the AM/PM symbols in the digital display.
The proper date will be calculated by the internal microprocessor.
And at the end of the adjustment the display returns to the default
value.
5. Replacing the battery
A low battery is signaled by the second hand remaining in the
12 o'clock position and a blinking ”
LO
” in the digital display.
The battery should be replaced by trained personnel to avoid damage
and ensure water resistance according to factory specifications.
After battery replacement your Junghans atomic watch will automati-
cally receive the WWVB signal and set itself to Pacific standard time.
You must then either press the T1 button to confirm the time or set the
desired time zone as described in 4. Setting the time zone.
Dependent on your location and/or the time of day it may take bet-
ween 3 and 30 minutes for a successful reception of the time signal.
If you find yourself outside of the reception range or in a
disturbance field, you need to synchronize the time manually as
follows.
Sync
hronizing the time after battery change:
In case the watch does not receive the WWVB-signal immediately
after the battery change, the time can be set manually as follows.
1) Press the T2 button to advance the hands. The hands can be advan-
ced either incrementally by repeatedly pressing the T2 button or
rapidly by holding the T2 button pressed. The digital display shows
the minutes.
2) Press the T1 button to confirm and set the time. The digital display
will go blank. It is not possible to set the date in the manual syn-
chronized mode.
After manual synchronization, your Junghans atomic watch attempts
to receive an automatic signal every hour on the hour until the
WWVB signal has been successfully received.
After having received a signal, the Junghans atomic watch sets itself
to Pacific standard time. You must then either press the T1 button to
confirm the time or set the desired time zone as described
in 4. Setting the time zone.
To Next Page
Loading...
