6 Mesa 3 Rugged Tablet Owner’s Manual
Attach the Hand Strap and Stylus Tether
A hand strap, ne tip capacitive stylus, and tether are
included with the Mesa 3.
Hand Strap
To attach the hand strap to the Mesa 3, follow the images
below. You can attach it to the right or left side of the tablet:
Stylus Tether
1. Attach one end of the stylus tether to the stylus.
2. Push the free tether loop through one of the tether
attachment points located on the side of any of the four
corners of the Mesa 3.
3. Insert the stylus with the attached tether through this
loop and tighten the loop.
4. Place the stylus into the stylus storage slot located on
the bottom of the Mesa 3.
1
2
3
To Next Page
Loading...
