Chapter 1 Contents 5
helps you pull the battery out). Place the back edge
in rst, gently pushing it underneath the two battery
catches. Rotate the front edge down until it is in position.
CAUTION: Do not insert the battery pack straight down.
Damage to the unit could occur.
4. Replace the door and press down on it until the latch
pops into the locked position.
5. Attach the appropriate plug for your country into the
AC wall charger and plug it into a wall socket. Plug the
other end into the DC power jack on the Mesa 3.
Note: Use the AC wall charger that came with the Mesa
3 or another approved charger from Juniper Systems.
6. Charge the battery pack at room temperature (68°F or
20°C) for 6 hours (for the rst charge). While the battery
pack is charging, the red LED blinks. When it is fully
charged and external power is applied, the red LED is
solid.
Note on optional internal battery: the Mesa 3 does not
recognize an internal battery until the Mesa 3 is being
charged.
Perform Set Up
The rst time the tablet is powered on, Windows setup
options are shown. Follow the prompts to set up your unit as
desired.
!
Black Tab
To Next Page
Loading...
