28 Mesa 3 Rugged Tablet Owner’s Manual
Home Screen
When the Barcode Connector utility loads, the home screen
appears. From the home screen, you can do a Scan Test
right away. Aim the imager towards a barcode. Tap Scan
on the screen or press the scan button on the keypad (p2
is the default). When a red aiming LED appears, place it
on or near the barcode. After a successful scan, the Scan
Symbology Type and Scan Data are shown on the screen.
Barcode Menu
Select the menu symbol in the upper left hand corner of the
home screen or swipe the screen from left to right to see the
menu (you can do this from any screen in the application).
This menu gives you access to several setting screens.
User Settings
From the menu, select User to open the User Settings screen.
From this screen, set up options like Barcode Scan Time and
which button to use to scan barcodes.
To Next Page
Loading...
