Juniper PTX1000 - User Manual

Quick Start Guide
PTX1000
IN THIS GUIDE
Step 1: Begin | 1
Step 2: Up and Running | 4
Step 3: Keep Going | 6
Step 1: Begin
IN THIS SECTION
Mount the PTX1000 | 2
Connect Power to the PTX1000 | 3
To install and configure a Juniper Networks PTX1000 Router, you need:
•
Either a mechanical lift or two people to lift the PTX1000 into place and another person to secure it to the rack
•
An electrostatic discharge (ESD) grounding strap (not provided)
•
A pair of front-mounting rails (provided)
•
A pair of rear-mounting blades (provided)
•
Flat-head M4x6-mm Phillips mounting screws to secure the mounting rails to the chassis (24 screws are provided—11
for each side and 2 extra screws)
•
Sixteen screws to secure the chassis and mounting blades to the rack (not provided)
•
Screwdriver appropriate for the rack mounting screws (not provided)
•
Four power cords with plugs appropriate for your geographical location (provided)
•
RJ-45 cable and RJ-45 to DB-9 serial port adapter (provided)

Juniper PTX1000 Specifications

General

Brand	Juniper
Model	PTX1000
Category	Network Router
Language	English

Summary

Step 1: Begin

Mount the PTX1000

Mounting the PTX1000 router in a standard 19-inch, four-post rack configuration.

Connect Power to the PTX1000

Connecting AC power supplies to the PTX1000 router and verifying power status.

Step 2: Up and Running

Set Parameter Values

Required console parameter values for initial PTX1000 configuration, including baud rate and data bits.

Perform the Initial Configuration

Steps to connect to the PTX1000 console, log in, and start the command-line interface (CLI).

Step 3: Keep Going

Safety Warnings Summary

Summary of safety warnings for installing and operating the PTX1000, emphasizing qualified personnel.

Power Cable Warning (Japanese)

Warning regarding the use of the attached power cable, specific to Japanese language users.

Contacting Juniper Networks

Information on how to contact Juniper Networks for technical support and accessing support resources.