What to do if Juniper Network Router temperature sensor is too hot?
If a temperature sensor on your Juniper Network Router reports that it's too hot, first check the environmental conditions and alarms on other devices. Make sure that environmental factors, like hot air blowing around the equipment, aren't affecting the temperature sensor. If the problem continues, the device might shut down.
What to do if my Juniper PTX1000 Network Router management Ethernet 1 link is down?
If the Management Ethernet 1 link is down on your Juniper Network Router, check if a cable is properly connected to the management Ethernet interface and ensure the cable is not defective. If needed, replace the cable. If the problem persists, open a support case.
What to do if Juniper PTX1000 Network Router PEM airflow doesn't match chassis airflow?
If the PEM airflow doesn't match the chassis airflow on your Juniper Network Router, replace the power supply with one that supports the same airflow direction as the chassis.
What to do if Juniper PTX1000 fan is not spinning?
If a fan is not spinning in your Juniper Network Router, remove the fan module and check for any obstructions. After checking, reinsert the fan module. If the problem continues, replace the fan module.
How to fix Juniper Network Router power supply type mismatch?
To resolve a power supply type mismatch in your Juniper Network Router, check if there's a mix of AC and DC power supplies in the same chassis. Reboot the device using only AC or only DC power supplies.
What to do if Juniper PTX1000 PEM is not supported?
If your Juniper Network Router indicates that a PEM is not supported, replace the power supply with a supported one.
What to do if Juniper PTX1000 Network Router PEM is not powered?
If a PEM is not powered in your Juniper Network Router, check the power cord connection and reconnect it if necessary.
What to do if Juniper PTX1000 temperature sensor fails?
If a temperature sensor fails on your Juniper Network Router, check the system log for the following message and report it to customer support: Temp sensor sensor-number failed, where sensor-number ranges from 1 through 10.
What to do if Juniper PTX1000 Network Router PEM I2C fails?
If a PEM I2C failure occurs on your Juniper Network Router, check the system log for one of the following messages and report the error message to customer support: * I2C Read failed for device number, where number may be from 123 to 125. * PS number: Transitioning from online to offline, where power supply (PS) number may be 1, 2, 3, or 4.
What to do if Juniper Network Router fan I2C fails?
If a fan I2C failure occurs in your Juniper Network Router, check the system log for one of the following messages and report the error message to customer support: * CM ENV Monitor: Get fan speed failed. * fan-number is NOT spinning @ correct speed, where fan-number can be 1, 2, or 3.
General| Brand | Juniper |
|---|---|
| Model | PTX1000 |
| Category | Network Router |
| Language | English |
To Next Page
