Juniper PTX1000 - Maintaining the PTX1000 Transceivers and Fiber-Optic Cables

Figure 41: Installing a Power Supply in a PTX1000
NOTE: Each power supply must be connected to a dedicated power source outlet.
NOTE: If you have a Juniper Care service contract, register any addition, change, or upgrade of
hardware components at https://www.juniper.net/customers/support/tools/updateinstallbase/
. Failure to do so can result in significant delays if you need replacement parts. This note does
not apply if you replace existing components with the same type of component.
Maintaining the PTX1000 Transceivers and
Fiber-Optic Cables
IN THIS SECTION
Removing a Transceiver from the PTX1000 | 105
Installing a Transceiver in the PTX1000 | 106
Disconnecting a Fiber-Optic Cable from the PTX1000 | 108
Connecting a Fiber-Optic Cable to the PTX1000 | 109
Maintaining Fiber-Optic Cables in a PTX1000 | 110
104