Juniper PTX1000 - PTX1000 Chassis Status Leds

PTX1000 Chassis Status LEDs
The PTX1000 has four status LEDs on the management panel of the chassis, next to the network ports
(see Figure 12 on page 35).
Figure 12: Chassis Status LEDs on a PTX1000
3—1— Minor alarm (MIN) LEDPower (PWR) LED
4—2— Status (STS) LEDMajor alarm (MAJ) LED
Table 10 on page 35 describes the chassis status LEDs on a PTX1000.
Table 10: PTX1000 Chassis Status LEDs
DescriptionStateColorName
The PTX1000 is powered off— there is no power to the device.OffUnlitPower
(PWR)
The power system is working correctly.On steadilyGreen
There is a problem with the power system. Power off the
PTX1000 by setting the AC power source outlet to the off (O)
position or by unplugging the AC power cords. Correct any
voltage issues. Power on the PTX1000 and monitor the power
supply and fan LEDs to help determine where the error is
occurring. If there is a CPU power failure, the PTX1000 does
not boot.
BlinkingAmber
The PTX1000 is powered off or Junos OS is halted.OffUnlitStatus (STS)
LED
Junos OS has booted.On steadilyGreen
The PTX1000 detects a fault.BlinkingAmber
35