Juniper PTX1000 - Port Panel and Management Panel

Port Panel and Management Panel
The port panel of the PTX1000 contains 72 network ports and port LEDs. The management panel of the
PTX1000 contains console and management ports, a reset button, system status LEDs, clocking ports, and
a USB port. Figure 1 on page 19 shows the PTX1000 port panel and management panel.
Figure 1: PTX1000 Port Panel and Management Panel
2—1— Management panelPort panel
Each of the 72 network ports on the port panel supports quad small form-factor pluggable plus (QSFP+)
transceivers, and is configured as a channelized 4 x 10-Gigabit Ethernet interface by default (for a maximum
of 288 10-Gigabit Ethernet ports). You can configure each of the 72 ports as a 40-Gigabit Ethernet interface.
You can also configure 24 of the 72 network ports as 100-Gigabit Ethernet interfaces. Table 3 on page 19
describes the maximum number of ports for each interface type supported by the PTX1000.
Table 3: Maximum Supported Ports at Each Interface Speed
Maximum Supported PortsInterface Type
28810-Gigabit Ethernet
7240-Gigabit Ethernet
24100-Gigabit Ethernet
NOTE: You can purchase a licensed model of the PTX1000 that allows you to use 18 of the 72
network ports. You can use 18 ports in any combination, for a maximum of 72 10-Gigabit Ethernet
interfaces, 18 40-Gigabit Ethernet interfaces, or 6 100-Gigabit Ethernet interfaces. You can
purchase additional licenses to enable the remaining network ports. Each license enables an
additional 18 of the 72 total network ports.
19