Management Port Connector Pinouts for the PTX1000
The 10/100/1000BASE-T RJ-45 management port (labeled MGMT) uses an RJ-45 connector to connect
to a management device for out-of-band management.
Table 28 on page 70 provides the pinout information of the RJ-45 management port connector. An RJ-45
cable is supplied with the PTX1000.
Table 28: RJ-45 Management Port Connector Pinouts for the PTX1000
DescriptionSignalPin
Transmit/receive data pair 1TRP1+1
Transmit/receive data pair 1TRP1–2
Transmit/receive data pair 2TRP2+3
Transmit/receive data pair 3TRP3+4
Transmit/receive data pair 3TRP3–5
Transmit/receive data pair 2TRP2–6
Transmit/receive data pair 4TRP4+7
Transmit/receive data pair 4TRP4–8
Console Port Connector Pinouts for the PTX1000
The console port (labeled CON) is an RS-232 serial interface that uses an RJ-45 connector to connect to
a console management device. The default baud rate for the console port is 9600 baud.
Table 29 on page 71 provides the pinout information for the RJ-45 console connector. An RJ-45 cable
and an RJ-45 to DB-9 adapter are supplied with the PTX1000.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you want to connect
your laptop or PC directly to a PTX1000, use a combination of the RJ-45 cable and RJ-45 to
DB-9 adapter supplied with the router and a USB to DB-9 male adapter. You must provide the
USB to DB-9 male adapter.
70
To Next Page
Loading...
