- 18 -
ROSIN PRESS WILL NOT HEAT PROPERLY
* Check that both power switches on the left and right sides of the press are ON. Top and
bottom plattens each need to be turned on separately.
* Re-run AT calibration procedure described on page 7 of this User Manual
* If SV (requested) temperature varies significantly from PV (actual) temperature, adjust
oset using P4 calibration method described on page 9 of this User Manual
If your issue is not resolved here, it may already be addressed in the user forums
or online support section at https://support.uscutter.com/support/home
Preserve the shipping carton: Please do not discard or disassemble the carton this rosin
press came in. It was designed to hold the weight of this machine during shipping.
Should you need to return the equipment due to warranty or repair, you will need it. Do
not attempt to ship this equipment in a dierent container.
To Next Page
Loading...