- 5 -
UNBOXING / FIRST TIME SET-UP
1) Remove the rosin press from the cardboard shipping carton, taking special care to re-
move all Styrofoam bits, plastic wrap or any other materials that may melt or catch fire.
2) Set-up the press in a well ventilated and dry location, free of any flammable materials
when being used.
3) Place the press on a level flat surface with sucient work area around the press where
it cannot touch other objects when the platen swings fully to either side.
4) For added safety, bolt the feet of the press to the table or flat surface to prevent the
press from tipping over when the handle is pressed down.
5) Connect the power cord into a properly grounded three prong electrical outlet with a
minimum 20 amp rating. Circuits with less than 15 amps, or circuits shared with other high
demand equipment should not be used.
If using an extension cord, it should be as short as possible and not less than 12 gauge.
Heavy duty cords are recommended.
To Next Page
Loading...
Need help?
General