48
5 Maintenance
Rinsing the milk system
After each milk preparation, the JURA prompts you
to perform a milk system rinse.
Precondition:
READY / M-RINSE is displayed.
T Place a receptacle under the dual spout.
T Press the Rotary Switch to start milk system
rinsing.
RINSING, the milk system is rinsed.
The rinse stops automatically.
READY
appears on the display.
Cleaning the milk system
To ensure that the milk system in the dual spout
always works properly, you must clean it daily
when you have been preparing milk.
CAUTION
If the wrong cleaning agent is used, the machine
could be damaged and/or traces could be left
behind in the milk.
T Use only original JURA maintenance
products.
E JURA milk system cleaner is available from
specialised dealers.
E To clean the milk system, use the container
supplied.
T Press and hold the Rotary Switch until
RINSE appears.
T Press the Rotary Switch to enter the
programme item.
M-CLEAN
T Press the Rotary Switch to start milk system
cleaning.
AGENT FOR M-CLEAN
T Remove the milk pipe from the milk
container or carton.
T Add milk system cleaner to the front part of
the container up to the bottom mark
(indicated by 6).
T Then add water up to the top mark.
T Place the container under the dual spout.
T Connect the milk pipe to the container.
E To connect the milk pipe to the container
correctly, the pipe must be fitted with a
connector.
T Press the Rotary Switch.
CLEANING, the milk system and the pipe
are cleaned.
The operation is interrupted,
WATER FOR
M-CLEAN.
T Rinse the container thoroughly and fill the
front part with 250ml fresh water.
T Place the container under the dual spout
and connect the milk pipe with the container
again.
6
To Next Page
Loading...
Need help?
General
Weight and Dimensions
