To Next PageTo Next Page
Need help?Do you have a question about the Jura IMPRESSA A5 OT and is the answer not in the manual?
General| Programmable Beverages | Yes |
|---|---|
| Water Tank Capacity | 1.1 L |
| Coffee Grounds Container | Removable |
| Pump Pressure | 15 bar |
| Voltage | 230 V |
| Power Consumption | 1450 W |
| Type | Automatic Coffee Machine |
| Coffee Types | Espresso, Coffee |
| Bean Container Capacity | 200 g |
| Milk System | Manual |
| Display | Text display |
| Programmability | Programmable coffee strength, water volume, temperature |
| Height | 32 cm |
Instructions for removing the service cover and side panel for the 1st generation model.
Instructions for removing the service cover and side panel for 2nd gen and IMPRESSA A line models.
Steps for disassembling additional components like the brewing unit cover and hoses.
Step-by-step guide for removing the coffee spout from the ENA Micro 5 model.
Instructions for removing the coffee spout from IMPRESSA A5 OT and A9 OT TFT models.
Diagram identifying components located on the right side of the appliance.
Diagram identifying components on the left side, including the brewing unit.
Diagram identifying components located on the top of the appliance.
Diagram identifying components on the back of the appliance.
Overview of the power logic board and cable connections for the ENA Micro 9 One Touch.
Electrical block schematic for ENA Micro 9 OT and IMPRESSA A5 OT models.
Electrical block schematic for the IMPRESSA A9 OT TFT model.
Electrical block schematic for ENA Micro 1 and ENA Micro 5 models.
Diagram of multi-valve connections for ENA Micro 9 OT, A5 OT, and A9 OT TFT models.
Diagram of the fluid system for ENA Micro 1 and ENA Micro 5 models.
