Jura IMPRESSA E85 - Programming Settings

15
 Stats
 Language
 ML / OZ
 Rinse
Programming key (3)
Use the programming key (3) to open or quit the pro-
gramming mode (no saving of values effected).
Rotary Switch (1)
Turn the Rotary Switch (1) to change the adjusted values or
to select the next programming step.
Press the Rotary Switch (1) to check the values adjusted or
to save the values selected
15.1 Programming the filter
Refer to Chapter 5.1 «Installing the filter».
15.2 Programming the water hardness
Refer to Chapter 4 «Adjusting the water hardness».
15.3 Programming the aroma STANDARD or ROBUST
When the machine leaves the factory, the aroma is set to
robust. If requested it can also be set to Standard.
 READY
 Press programming key (3) until
FILTER – is displayed.
 The illuminated ring (2) is active.
 Turn the Rotary Switch (1) until Aroma is displayed.
 AROMA
 Press the Rotary Switch (1).
 ROBUST
 Turn the Rotary Switch (1) until the following message is dis-
played:
 STANDARD
 To confirm the new aroma settings, press the Rotary Switch (1).
 AROMA
 Press the programming key (3) to quit the programming
mode or select the next programming item using the Rotary
Switch (1).
 READY
15.4 Programming the automatic switch-off time
You can programme your IMPRESSA E80/85 such that it
will switch off automatically after a certain time. You can
programme the switch-off time in a range between 0.5 and 9
hours, or select ––:–– (i.e. inactive).
 READY
 Press programming key (3) until
FILTER is displayed.
 The illuminated ring (2) is active.
 Turn the Rotary Switch (1) until AUTO OFF is displayed.
 AUTO OFF
 Now press the Rotary Switch (1) to start programming the
switch-off time. Switch-off time AUTO OFF ...HRS
 5.0 HRS
 Turn the Rotary Switch (1) to adjust the hours.
 1.0 HRS
 To confirm the new switch-off time, press the Rotary Switch (1).
 AUTO OFF
E