Jura IMPRESSA E85 - De-Scaling the IMPRESSA E80;85 Without Display Request

20
 EMPTY
DRAWER
 Empty the drawer
 DRAWER
MISSING
 Insert the drawer again.
 SOLVENT
IN TANK
Completely dissolve the content of one blister (3 tablets) in a jug
containing 0.5 litres of water, and fill the mixture in the water tank.
Reinstall the water tank.
 SOLVENT
IN TANK
OPEN TAP
 Put a sufficiently large container under the replaceable hot water
nozzle (17).
 Open the steam / hot water draw-off valve (15) (Fig. 13)
 DECAL ON
 SHUT TAP
 Close the steam / hot water draw-off valve (15).
 DECAL ON
 EMPTY
DRAWER
 Empty the drawer
 DRAWER
MISSING
 Insert the drawer again.
 FILL
WATER
Rinse the water tank thoroughly and fill it with cold, fresh
tap water. Install it again.
 OPEN TAP
 Open the steam / hot water draw-off valve (15) (Fig. 13)
 DECAL ON
 SHUT TAP
 After you have closed the steam / hot water draw off tap (15),
the following message is displayed
 DECAL ON
 EMPTY
DRAWER
 Empty the drawer
 DRAWER
MISSING
 Insert the drawer again.
 PRESS
RINSE
 Press the maintenance key (9).
 RINSE
 READY
 The de-scaling operation was completed successfully.
18.1 De-scaling the IMPRESSA E80/85 without
display request
 Press the maintenance key (9) until
RINSE is displayed
 Turn the Rotary Switch (1) until
DECAL ON is displayed
 Press the Rotary Switch (1)
 Now, the “De-scaling” program is activated. Now, proceed as
described in Chapter 18 as from
EMPTY DRAWER.