Jura IMPRESSA X90 User Manual

8
 If using acidic decalcifying agents be sure to immediately re-
move any splashes and drops from delicate surfaces, especially
natural stone and wooden surfaces, or take corresponding pre-
cautions.
3. Check before use
3.1 Checking mains voltage
The machine is set for the correct voltage before leaving our
factory. Ensure that your mains voltage corresponds to the details
quoted on the rating plate attached to the bottom of the machine.
3.2 Checking fuse
The machine is designed for a current of 10 amps. Check that an
appropriate fuse is fitted.
3.3 Adding coffee beans
To ensure that your machine will work perfectly for a long
time and to avoid damage, please note that the grinding gear
of your Jura coffee machine is not suitable for coffee beans
which were treated, during or after roasting, with additives
(e.g. sugar). Such coffee blends may damage the grinding
gear. Any repair costs resulting from the use of such blends
are not covered by warranty.
 Lift up cover of the bean container (13) and remove aroma pro-
tection lid.
 Clean out any dirt or foreign object from the bean container.
 Fill the grinder container (Fig. 1) with coffee beans, replace
aroma protection lid and close the cover.
3.4 Adjusting grinder
You can adjust the grinder to the roast of your coffee. We recom-
mend the following:
for a light roast  a finer adjustment
for a dark roast  a coarser adjustment
 Open the cover of the bean container (13).
 To adjust grinding turn selector switch (Fig. 1) to the desired
position.
 You have the following possibilities:
the smaller the dots, the finer the grinding
the bigger the dots, the coarser the grinding
The grinding grade should only be adjusted while the grinder
is working.
4. Preparing machine
4.1 Fill system with water
 Switch your machine on by pressing ON/OFF key . The
machine adjusts fully-automatically to the starting position.
 PLEASE WAIT
 FILL SYSTEM / PRESS STEAM
 Press key .
 FILL WATER
 Remove water tank and rinse well with clear tap-water.
 Fill water tank and replace. Make sure that tank engages well.
 FILL SYSTEM / PRESS STEAM
 Place a container under the pivoting nozzle (20) and press key
.
 PLEASE WAIT
 RINSE UNIT

Jura IMPRESSA X90 Specifications

Power

voltage	230 V AC
output	1350 W
fuse	10 A

Energy Consumption

energy consumption standby	4.4 Wh
energy consumption ready to make coffee, economy mode on	31 Wh
energy consumption ready to make coffee, economy mode off	41 Wh

Capacity

capacity, bean container	280 gr
capacity, grounds container	40 port
water tank capacity	5.7 litres

Performance

pump pressure	max. 15 bar
cable length	1.1 m

Weight and Dimensions

weight	15 kg
dimensions	41 x 47 x 39 cm