Juzisound Total SOLO Sampler MICRO - Information for Users on Collection and Disposal of Old Equipment

Page 4 of 13
Information for Users on Collection and Disposal of Old
Equipment
This symbol on the products, packaging, and/or accompanying documents means
that used electrical and electronic products should not be mixed with general
household waste.
For proper treatment, recovery and recycling of old products, please take them to
applicable collection points, in accordance with your national legislation and the
Directives 2012/19/EU.
By disposing of these products correctly, you will help to save valuable resources
and prevent any potential negative effects on human health and the environment
which could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products, please contact your local mu-
nicipality, your waste disposal service or the point of sale where you purchased the items.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for
further information.
Information on Disposal in other Countries outside the European Union
This symbol is only valid in the European Union. If you wish to discard these items, please contact
your local authorities or dealer and ask for the correct method of disposal.
EU Compliance
Juzisound Total SOLO Sampler MICRO is CE compliant.
Note that any cables supplied with this equipment may be fitted with ferrite rings at each end. This is to
comply with the current regulations and these ferrites should not be removed.
Electromagnetic Compatibility
This product complies with the requirements of European Union’s Directive: 2014/30/EU
EN 55032:2015, Environment: Class B, EN 55035:2017, Environments: E1 - E4, EN 61000-3-2:2019, EN 61000-3-3:2013, EN
61000-4-2:2009, EN 61000-4-4:2012, EN 61000-4-5:2014, EN 61000-4-6:2014, EN 61000-4-8:2010, EN 61000-4-11:2020,.
Audio input and output ports are screened cable ports and any connections to them should be made using braid-screened cable and
metal connector shells in order to provide a low impedance connection between the cable screen and the equipment.
LVD
This product complies with the requirements of European Union’s Directive: 2014/35/EU.
RoHS notice
This product complies with the requirements of European Union’s Directive 2011/65/EU.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This product has been tested and found to comply with the limit for a Class B Digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide a reasonable protection against harmful interference in a residential environment. This
equipment generate, use and radiate radio frequency energy and, if not installed and used according to the instructions found in the
users manual, may cause interferences harmful to the operation to other electronic devices. Compliance with FCC regulations does
not guarantee that interferences will not occur in all the installations. If this product is found to be the source of interferences,
witch can be determined by turning the unit “OFF” and “ON”, please try to eliminate the problem by using one of the following
measures:
• Relocate either this product or the device that is affected by the interference.
• Use power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter(s).