JVC AX-222BK - Specifications

Specifications
OVERALL CHARACTERISTICS
Output power
40 watts per channel into 8 ohms at 1 kHz
(DIN),
35 watts per channel, min. RMS, both chan-
nels driven, into 8 ohms from 40 Hz to 20
kHz, with no more than 0.007% total har-
monic distortion.
35 watts per channel, min. RMS, both chan-
nels driven, into 8 ohms at 1 kHz with no
more than 0.003% total harmonic distor-
tion. (measured by JVC Audio Analyzer
System)
Total harmonic
distortion
intermodulation
distortion
Power band width
Frequency response
Damping factor
Input terminals
Input sensitivity/
impedance (1 kHz)
PHONO
CD/AUX/
TUNER/TAPE
Signal-to-noise ratio
PHONO
CD/AUX/
TUNER/TAPE
MONITOR
PHONO
(REC OUT)
CD/AUX/
TUNE R/TAPE
MONITOR
(SP OUT)
PHONO
CD/AUX/
TUNER/TAPE
MONITOR
: 0.007% (40 Hz —
20 kHz, 8 ohms) at
35 watts
: 0.007% (60 Hz: 7 kHz
=4:1,80hms) at
35 watts
: 7 Hz — 50 kHz (IHF,
0.05%, 8 ohms both
channels driven)
: 6 Hz — 80 kHz +0,
—3 dB (8 ohms)
> 35 (1 KHz, 8 ohms)
: 2.5 mV/47 kohms
: 150 mV/39 kohms
: 71 dB (66 IHF)
: 100 dB (66 IHF)
: 80 dB ('78 IHF)
: 76 dB ('78 IHF)
: 67 dB (DIN)
: 68 dB (DIN)
Tone controls
Loudness controls
(Volume control at
—30 dB position)
EQUALIZER
PHONO overload
capacity
PHONO
PHONO RIAA
deviation
PHONO
Recording output
Output jevel/
impedance
TAPE REC
GENERAL
Dimensions
Weight
: TREBLE:
BASS:
AX-222BK
+8 +1dB
—8 +1dB
(at 10 kHz)
+8 +1dB
—8 +1dB
{at 100 Hz)
: +6 dB (at 100 Hz)
+4 dB (at 10 kHz)
: 100 mv (0.02% THD)
+0.5 dB (20 Hz —
20 kHz)
: 150 mV/900 ohms
: 435 (W) x 92 (H) x
252 (D} mm
(17-3/16" x 3-5/8" x
7-15/16")
: 4.4 kg (9.7 Ibs)
Design and specifications subject to change
without notice.
POWER SPECIFICATIONS
Areas
|
Line
Voltage
&
Frequency
Power
Consumption
ULK.
7 AC 240 V ~, 50 Hz 220 watts
Australia
Continental Europe AC 220 V ~\,, 50 Hz |
Saudi Arabia | AC127 / 220 V ~ selectable, 50/60 Hz 100 watts |
Other areas
AC 110/120 / 220 / 240 V ~ selectable, 50/60 Hz
(No. 20025) 1-3