JVC AX-V4BK User Manual

Or}
Connecting Audio/Video Components
You can connect the following components to the AX-V4BK using cables with RCA pin plugs.
Audio Components
+ Turntable
Video Components
* VCR
* CD player « Video disc player
+ Cassette deck * TV
> Tuner —___
Notes:
* Both plugs and jacks are color-coded; the red ones are for right audio signals, the white ones for left audio
signals, and yellow ones for video signals.
+ Any turntables incorporating a small-output cartridge such as an MC (moving-coil type) must be connected
to the AX- V4BK through acommercial head amplifier or step-up transformer. Direct connection may result
in insufficient volume.
Audio component connections
To audio output wes
To audio output
To audio output
Ifa ground cable is provided
for your turntable, connect
the cable to the screw marked
GND on the rear panel. To audio outp
Video component connections
To video output
To video input
ES Fes ss |
Video disc slaiiet Tv
CAUTION:
Ifyou
connect
a
sound-increasing
device
such
as
a
graphic
equalizer
between
the
source
components
and
the
AX-V4BK,
the
sound
output
through
the
AX-V4BK
may
be
distorted.
Page 7
a
a
Connecting
Audio
Components
for
the
COMPU
LINK-3
Remote
Control
System
SK —SSSSSSSSSSSSSSSFSsseeSeSeseSFSSSSSSSSSSSSSSSSSSSsFFsseseeee
The COMPU LINK-3 remote control system allows you to control other JVC audio components from the
AX-VA4BK or vice versa. To use this system, connect your JVC audio components and the AX-V4BK with
the cable (monaural mini-plug) supplied with those components.
Hf your audio component has two COMPU LINK-3 SYNCHRO jacks, you can use either one.
If it has only one COMPU LINK-3 SYNCHRO jack, connect it so that it is the Last item in the series of
components. (for example, the turntable in the diagram below)
Notes:
+ The COMPU LINK-3 remote control system is the upgraded version of the COMPU LINK-] and COMPU
LINK-2. Even if your component has the COMPU LINK-1 or COMPU LINK-2 jacks, you can still connect
it in the COMPU LINK-3 remote control system, but some functions may not work correctly.
* For more information about the COMPU LINK-3 (-1 and -2) remote control system, see page 17.
Cassette deck
Power Supply through the AX-V4BK to a Connected Component
‘AC OUTLET You can use the AC outlet on the rear of the AX-V4BK to supply power to an audio component.
This AC outlet is a “switched” outlet. So when the AX-V4BK is off (that is, in standby mode), power is not
supplied through this outlet. By tuming the AX-V4BK on and off, you can turn the connected component on
and off at the same time.
Note:
Do not use the AC outlet on the rear of the AX-V4BK to supply power to the component in the COMPU LINK
: remote control system; otherwise, the COMPU LINK remote control system may not work tly.
For Continentat Europe 2 i is ntrol system may not work correctly.
AC OUTLET
CAUTION:
De not plug the component to the AC outlet on the rear if the maximum consumption is greater
than indicated by the AC outlet.
For the U.K.
Page 8
MavA-XV

JVC AX-V4BK Specifications

General

Brand	JVC
Model	AX-V4BK
Category	Amplifier
Language	English