JVC CA-D5T - Three Ways to Select a Station; To Change the FM Reception Mode

Three ways to select a station
CHJuiiSenf=7 Press the TUNING << or bP button on the Unit repeatedly to move from frequency to
frequency until you find the one you want. (Manual Tuning).
OR
Hold down the TUNING <¢ or ® button on the Uint, the frequency starts changing on the
display. When a station is tuned in, “TUNED” lights up on the display and the frequency stops
changing. (Auto Tuning).
OR
{) (Possible only after presetting stations.)
Press once and release the <4 or >i button on the Unit to go to the next preset station, or
hold the k¢<4 or >i button on the Unit to cycle through the preset stations: release the button
when the preset station you want shows on the display.
You can also use the Remote Control to tune in preset channels:
1. Press the TUNER button so that you can receive the most recent station tuned in.
2. Select the station by entering the preset number in the numeric keys of the Remote Control.
Q Example: for channel 5, press 5. For channel 15, press +10 then 5. For channel 20, press
+10, then 10. For channel 32, press +10 three times, then 2.
Presetting Stations
You can store up to 40 of your favorite radio stations (FM and AM (MW/LW)) in memory, giving
you quick, easy access to the stations.
7. Select a band by pressing the FM/AM button.
2 2. Press the TUNING << or >> button on the Unit to tune in a station.
Geto) 3. Press the SET button.
The SET button indicator comes on, the preset number and “MEMORY” appears in the display
and blinks for five seconds.
3 = { During these five seconds while blinking, you can assign a channel number to the station
: and enter it into the memory.
4. Select a channel number by pressing the <4 or >> button on the Unit until you find the
channel number you want.
4.
5. Press the SET button and the station will be assigned to the channel number showing on the
display.
“MEMORY” appears in the display.
ha fo pd TE CT
oxo Pik Vice |
QO Ifa station has been previously stored using the same channel number, this will be erased
and the newly selected station will be stored.
QO If the “MEMORY” indicator goes off, start again from step 3.
5.
6. Repeat steps 1 - 5 for each station you want to store in memory with a preset number.
CAUTION: If the Unit is unplugged or if a power failure occurs, the preset stations will be erased in
a few days. If this happens, preset the stations again.
To Change the FM Reception Mode
When an FM stereo broadcast is hard to receive or noisy, press the FM MODE/MUTE button (or
FM MODE button on the Remote Control) so that the “AUTO” indiactor goes off in the display.
Reception improves, but there are no stereo effects, In this monaural mode, noisy comes out while
tuning in stations (since muting is also canceled).
oe ae To restore the stereo effect, press the FM MODE/MUTE button (or the FM MODE button on the
Remote Control) so that the “AUTO” indicator lights up. In this stereo mode, no noise comes out
while tuning in stations, and you can hear stereo sounds when a program is broadcast in stereo.