JVC CA-D5T - Page 21

osc@p>
0
Discgp
U0
cD
10KEY
Z. Select a disc with the DISC buttons (1-3).
The display changes to the Program Entry display and the disc number and track number
sections
blink
for
a
few
seconds.
The
DISC
buttons
(1-3),
SET
button
and
@<
or
1
buttons
on the CA-DST also blink.
@
>)
Disc Track Step iy
number number number
Q
While
the
display
is
blinking,
perform
the
operations
in
steps
3
to
4.
When
the
blinking
display
changes
to
the
“PROGRAM”
display,
repeat
the
operations
in
steps
2
to
4.
3. Press the CD 10KEY button.
4. Press the numerc keys (1 to 10 and +10) to select the track to program.
(J Example: for track 5, press 5. For track 15, press +10 then 5. For track 20, press +10, then
10. For track 32, press +10 three times, then 2.
The
blinking
disc
number
and
track
number
changes
to
the
step
number
display.
Also,
the
blinking buttons on the CA-DST stop blinking, but remain lit.
5. Repeat steps 2 to 4 to select the other tracks for the program.
6. Press the > button.
The Unit plays the tracks in the order you have programmed them.
Using the Unit
1. Press the PROGRAM/RANDOM button.
The message “PROGRAM” appears in the display and the PROGRAM indicator comes on.
If a program is already running, the track number blinks.
(The
display
changes
with
each
press
of
the
PROGRAM/RANDOM
button,
as
shown
below.
~
PROGRAM
—
RANDOM
—
Off
(Continuous
Play)
->
(back
to
the
beginning)
Z. Select a disc with the DISC buttons (1 to 3).
The display changes to the Program Entry display and the disc number and track number
sections
blink
for
a
few
seconds.
The
DISC
buttons
(1-3),
SET
button
and
<4
or
1
buttons
on the CA-DST also blink.
Disc Track Step
number number number
( While the display is blinking, perform the operations in steps 3 to 4. When the blinking
display changes to the “PROGRAM” display, repeat the operations in steps 2 to 4.
17