8
Introduction
This page is for when operating your TV using the
remote control of this product.
Setting the manufacturer's code
1 Slide the remote control mode
selector to the TV side.
2 Keep pressing down F TV.
NOTE
Keep pressing down F TV until Step 4 is complete.
3 Press ENTER and release.
4 Press number buttons (1-9, 0).
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
If there are more than one manufacturer’s codes,
try them in turn and select the one that causes the
product to work properly.
5 Release F TV.
For TV operation
Operate the remote control by pointing it towards
the TV.
*1 Make sure to slide the remote control mode
selector to the TV side in advance.
NOTE
When the batteries are replaced, perform the
manufacturer's code setting again.
Operating the TV using
the remote control
Number
buttons
Manufacturer Code Manufacturer Code
JVC 01 Samsung 12
Hitachi 10 Sanyo 13
Magnavox 02 Sharp 06
Mitsubishi 03 Sony 07
Panasonic 04, 11 Toshiba 08
RCA 05 Zenith 09
Turn ON/OFF the power.
Change channels.
Adjust volume.
Select channels.
Alternates between the
previously selected channel
and the current channel.
Switch TV and video input.
100+
9
*1
Getting started
EXA1[UJ].book Page 8 Monday, January 19, 2004 1:54 PM
To Next Page
Loading...
Need help?
General
