JVC CA-UXG200 - Clock Setting and Sleep Timer

12
Setting the Clock
Set the clock before using the Daily Timer (see page 16).
• You can set the clock only when the System is turned off
(on standby).
1 Turn off (standby) the System.
2 Activate the clock setting mode.
3 Adjust the hour.
4 Adjust the minute.
The built-in clock starts working.
To check the current time during play
The time is displayed for a few seconds.
If there is a power failure
The clock loses its settings and “AM 12:00” flashes. You
need to set the clock again.
Turning Off the Power Automatically
—Sleep Timer
1 Activate the sleep timer mode.
2 Specify the shut-off time (in minutes).
To check the time remaining until the shut-off time
• If you press the button repeatedly, you can change the shut-
off time.
CLOCK/
SLEEP
2 sec.
SLEEP
REPEAT1
TRACK WMA
GROUP
HBS JAZZ
PRESET
CLOCK/
SLEEP
PRESET
CLOCK/
SLEEP
CLOCK/
SLEEP
CLOCK/
SLEEP
SLEEP
2 sec.
CLOCK/
SLEEP
10 20 30 40 50
90 80 70 60
(Canceled)
OFF
CLOCK/
SLEEP
SLEEP
2 sec.
UX-G200[J].BOOK Page 12 Tuesday, December 2, 2008 3:05 PM