CH-X1500
1-14
2.5 Precautions reassembling
REFERENCE:
When reassembling, also refer to the disassembling proce-
dures.
2.5.1 Mounting the traverse mechanism assembly (See
fig.30~34)
(1) When mounting the pickup assembly, attach the feed slide
shaft assembly to the traverse chassis. Apply E-JC-525
grease to the shaft.
(2) Mount the middle gear and the feed slide shaft to the
traverse chassis and secure them with the screw O
through the shaft holder.
(3) Before attaching the mechanism board, move the pickup
to the outer edge position, then attach the mechanism
board using the screw M. At this time, check that the rest
switch is correctly placed.
(4) To mount the rack arm, first move the pickup to the middle
position and fixing it with the screw P.
CAUTION:
When reassembling the mechanism board, reattach the
flexible wire to connector CN603 on the mechanism
board, and then unsolder the sorting round point. Next,
reattach the mechanism board with screw M.
Fig.30
Fig.31
Fig.32
Fig.33
Fig.34
Pickup assembly
Shaft holder
Feed slide shaft
assembly
Middle gear
Traverse chassis
Feed motor
O
N
Spindle
motor
Shaft holder
Feed motor assembly
O
M
M
Flexible wire
Mechanism board
CN603
Rest switch
Flexible wire
Sorting round point
Pickup
Lack arm
Pickup
P
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
Loading...
