CH-X1500
1-4
SECTION 2
Disassembly method
Perform operations according to the items to be disassembled.
2.1 Replacement of the Pickup
(1) After removing the exterior (top and bottom).
(2) Proceed to the "2.5.8.Pickup replacement procedure" sec-
tion.
(3) When applying grease, refer to the Exploded View. Use
new grease.
2.2 Mechanism Section
(1) Remove the exterior (required section only).
(2) The mechanism section is designed so that each unit can
be removed separately.
(3) When reassembling, refer to 2-5.Precautions reassem-
bling. (Use new grease when applying grease.)
2.3 Exterior Section
2.3.1 Removing the bottom cover and front panel assem-
bly (See fig.1~4)
(1) Remove the screw A to unlock the mounting direction
knob located on the side of the main unit.
(2) Turn the mounting direction knob in the direction of the ar-
row using a coin, etc. to remove it. (The knob can be re-
moved only when it is set to this position.)
(3) Remove the four screws B attaching the bottom cover on
both sides of the main unit.
(4) Turn the unit upside down so the bottom surface is facing
upward.
(5) Lift the rear edge of the bottom cover slightly and lift the
side by grasping the DIN jack section on the side panel,
then turn it toward the front (raise upward) to remove the
bottom cover.
(6) Release the four joints on both sides of the front panel,
and turn the front panel toward the top cover (lower down)
to remove the front panel.
Fig.1
Fig.2
Fig.3
Fig.4
B B
BAB
Bottom cove
AB B
BB
Bottom cover
Bottom cove
DIN jack
Joints
Joints
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
Loading...
Need help?
General
