JVC COMPU LINK RX-305TN

=
AUTO
MEMORY
AM
channel
spacing
AM channel spacing switch is provided on the rear panel to select
The
auto-memory
feature
scans
frequencies
upward
and
presets
sta-
between
9
kHz
or
10
kHz
steps
depending
on
the
area
in
which
tions
as
they
are
tuned,
in
ascending
channel
number
order.
the
receiver
is
used.
(Not provided on units for Canada, Australia, United Kingdom and
1. Using the TUNING keys, select the frequency from which you want continental Europe.)
auto-memory to start (the lower-limit frequency).
2. Press the AUTO MEMORY key to light its indicator.
Continental Europe, U.K. 50 kHz
eM TOT
9 kHz*
Enter the starting channel number with the numeric keys while ay ne oud | = |
the indicator is on (about 5 seconds). :
Note: *Preset at the factory.
se
|
KUO
es,
ey,
First,
turn
the
power
ON,
then
disconnect
the
power
cord.
Wait
*
FM
[I
]
ES
ry
Miz
{.
for
a
few
seconds
and
switch
over
the
AM
channel
spacing
switch
(2
a
Ich
as
shown
in
figure
using
the
tip
of
a
ballpoint
pen.
@ If the indicator turns off before you enter the channel number,
press the AUTO MEMORY key again.
3. The auto-memory feature starts scanning frequencies upward.
The TUNED indicator will light when a station is tuned, with the
channel number blinking (for about 5 seconds).
Mur
ay ED TER
Las ae er ee
4. The presetting is complete when the MEMORY indicator is lit.
MUTE
(yt
ames
ae
ae
a
ars aa | ae
This continues until the upper-limit frequency is reached or all 40
channels are filled.
Note:
If you do not want to preset a station, resume scanning by pressing
the AUTO MEMORY key while the channel number is blinking. To
halt the auto-memory feature, press any TUNER key other than the
AUTO MEMORY key.
—10—