JVC COMPU LINK RX-305TN

Listening to AM or FM Broadcasts
= Selecting a Station
1.Press the AM (MW/LW) or FM key.
FM AM
2. Use the TUNING keys to find a station.
<< TUNING >
N
Hold the TUNING key down to change the frequency faster, then tap
the key to set the frequency precisely. In the RX-305LTN/
RX-304LBK when tuning reaches the upper limit of the LW
frequencies, it automatically skips to the lower limit of the MW fre-
quencies. The opposite may also occur.
CIT CUT oe
AW”
Auto-tuning starts when the TUNING keys are released and stops
when a station is tuned. To halt auto-tuning, press a TUNING key.
A three-digit number is used to display an FM frequency for equip-
ment exported to Canada.
3. The TUNED indicator will light when a station is tuned in correctly.
[TONED] [STERES] MUTE
Of Mens
ace a ven
Adjust the antenna if the indicator does not light.
@ While tuning in an FM station, press the FM MODE/MUTE key
to light the MUTE/AUTO indicator, this cuts out inter station noise
while tuning.
@ The STEREO indicator will tight when an FM stereo station is tuned
in correctly.
If the FM stereo station is weak and noisy, press the FM MODE/MUTE
key again to turn off the MUTE/AUTO indicator to improve reception
(broadcast becomes monaural).
= Presetting Stations
You
can
preset
a
total
of
40
AM
(MW/LW)
and
FM
station
(CH
1
through
CH
40).
1. Tune in the desired station with the TUNING keys.
MUTE
sTereo] MUTE
Pia
ED
A)
we
_I
f.
ILI
2.
Press
the
MEMORY
key
to
light
its
indicator.
revony
wre
mis mic}
FM LL L Mize
P\
a
ee
ge
|
ch
3.
Enter
the
channel
number
with
numeric
keys
while
the
indicator
is on (for about 5 seconds).
at)
oe]
(STERES]
TE
rm
CI
ILE)
¥
bs
ne
aa
a
@
If
the
indicator
turns
off
before
you
enter
the
channel
number,
press
the
MEMORY
key
again.
4. Repeat this procedure to preset other channels.
® Recalling preset channels
1. Press numeric keys to select a preset channel.
’ 2
(Fonen] (STeRES) ATS
CH- [3S mG lS0e be
® To indicate numbers 1 through 10, simply press the appropriate
keys.
To indicate numbers over 10, press the appropriate combination
of keys.
Examples;
To indicate 17, press ‘+10’, then ‘’7"'.
To indicate 20, press ‘'+ 10", then ‘‘10’’.
To indicate 26, press ‘'+ 10’ twice, then ‘‘6"’.
To
indicate
40,
press
‘‘+10’’
three
times,
then
‘’10°'.