JVC FS-G5

1-14 (No.MB353)
3.1.8 Removing the amplifier board/ heat sink
(See Fig.18, 19)
• Prior to performing the following procedure, remove the side
panel (R)/(L), the top panel, the main board, the transformer
board, the tuner pack and the fan.
(1) From top of the body, disconnect the wire from connector
CN101
and CN204 on the amplifier board.
(2) From top of the body, remove the five screws R attaching
the amplifier board.
(3) From the back of the body, remove the two screws T at-
taching the amplifier board.
Fig.18
Fig.19
CN101
CN204
Amplifier board
R
R
Rear panel
Rear panel
Amplifier board
T