JVC FS-G6 - Page 23

2-7
UX-G6/FS-G6
<Front panel assembly>
Removing the front board.
(See Fig.22 to 24)
• Prior to performing the following procedure,
remove the top cover
and the front panel assembly.
1. Remove the seven screws R attaching the front
panel cover on the back of the front panel assem-
bly.
2. Remove the four screws S attaching the front
board.
3. The multi-jog dial and the volume dial on the front
panel assembly also comes off when removing
the front board.
<Front sub panel assembly>
Removing the system control board/
operation switch board
(See Fig.25 and 26)
• Prior to performing the following procedure,
remove the top cover, the front panel assembly
and the front sub panel assembly.
1. Disconnect the harness from connector CN710
on the system control board.
2. Remove the five screws T attaching the system
control board.
3. Remove the four screws U attaching the opera-
tion switch board.
Fig. 22
Fig. 23
Fig. 24
Fig. 25
Fig. 26
Front panel assembly
Multi-jog dial
Volume dial
Front panel assembly
R
R
R
R
Front panel cover
SS
Front board
T
T
T
System control board
Front sub panel assembly
CN710
U
U
Operation switch board