2-38
UX-G6/FS-G6
Assembling (Figs. 11 to 13)
1. Set the cam gear in the position shown in the figure.
2. Set the spring as shown in the figure.
3. Set the solenoid plunger (shaft).
4. Attach to the mechanism base.
5. Slide the head return slider (white plastic) in the
direction shown by the arrow to position the stud.
6. Check the positioning of the plunger.
7. Set the cam gear with the screw (K).
8. Turn the cam gear and make sure that the headbase
moves back and forth.
Cam gear
K
Turn
Fig. 11
Spring
Insert in the slit.
Slider
This should be
positioned here.
Assembly so that the stud is positioned here.
Slide the head return slider a little in the derection
shown by the arrow during assembling
and insert the screw J (Fig. 8)
Fig. 12
Fig. 13
To Next Page
Loading...
