(No.MB355)1-13
3.1.7 Removing the rear cover/ rear panel
(See Fig.17 to 21)
• Prior to performing the following procedure, remove the side
panel (R)/ (L) and the top panel.
Reference:
You do not have to remove the tuner pack to remove the rear
cover/ rear panel.
(1) From top of the body, disconnect the wire from connector
CN205
on the amp board.
(2) From the back of the body, remove the five screws Q at-
taching the rear cover. The rear cover and the fan come off.
(3) From top of the body, disconnect the card wire from con-
nector CN401
on the main board.
(4) From the back of the body, remove the two screws P and
the eight screws R attaching the rear panel.
(5) From the back of the body, remove the four screws T at-
taching the heat sink bracket.
(6) Release the two joints d on both lower side of the rear pan-
el and remove the rear panel backward.
Fig.17
Fig.18
Rear panel
Tuner pack
Rear cover
Main board
CN401
Amp board
CN205
Rear panel
Raer cover
Q
Q
Q
Q
To Next Page
Loading...
