1-12 (No.MB355)
3.1.5 Removing the tuner pack
(See Fig.15)
• Prior to performing the following procedure, remove the side
panel (R)/(L) and the top panel.
(1) Disconnect the card wire from connector CN401 on the
main board.
(2) From the back of the body, remove the two screws N at-
taching the tuner pack.
Fig.15
3.1.6 Removing the speaker board
(See Fig.16)
• Prior to performing the following procedure, remove the side
panel (R)/(L) and the top panel.
(1) From top of the body, disconnect the wire from connector
CN102
on the amp board.
(2) From the back of the body, remove the two screws P at-
taching the speaker board.
Fig.16
Main board
CN401
Tuner pack
Rear panel
Rear coverzv
N
P
Rear panel
Amp board
Speaker board
Rear cover
Power (single) board