JVC FS-GD7 - Connecting and Playing External Media; USB Playback from PC; AUX Input for Other Devices

1-18 (No.MB355)
3.1.11 Removing the amp board/ heat sink
(See Fig.28, 29)
• Prior to performing the following procedure, remove the side
panel (R)/ (L), the top panel and the rear cover/ rear panel.
(1) From top of the body, disconnect the wire from connector
CN202
on the amp board.
(2) From top of the body, remove the three screws A' and one
screw B' attaching the amp board.
(3) Remove the two screws D' and the three screws E' attach-
ing the heat sink.
Fig.28
Fig.29
CN202
Amp board
A
'
B'
A'
A'
Amp board
Heat sink
D'
D'
E'