30
ENGLISH
Adjusting the sound
You can adjust the sound characteristics to your
preference.
1
Select the item you want to adjust.
Each time you press the
button, the adjustable items
change as follows:
Indication To do: Range
BAS*
1
Adjust the bass. –06 (min.)
|
+06 (max.)
TRE*
1
Adjust the treble. –06 (min.)
|
+06 (max.)
FAD*
2
Adjust the front R06 (Rear only)
and rear speaker |
balance. F06 (Front only)
BAL Adjust the left L06 (Left only)
and right speaker |
balance. R06 (Right only)
LOUD*
1
Boost low and
high frequencies LOUD ON
to produce a well- |
balanced sound LOUD OFF
at low volume
level.
VOL*
3
Adjust the volume. 00 (min.)
|
30 or 50 (max.)*
4
*
1
When you adjust the bass, treble, or loudness, the
adjustment you have made is stored for the
currently selected sound mode (C-EQ) including
“USER.”
*
2
If you are using a two-speaker system, set the fader
level to “00.”
*
3
Normally the control dial work as the volume
control. So you do not have to select “VOL” to
adjust the volume level.
*
4
Depending on the amplifier gain control setting.
(See page 34 for details.)
2
Adjust the setting.
3
Repeat steps
1
and
2
to adjust the
other items.
To reset each sound mode to the factory
settings, repeat the same procedure and
reassign the preset values listed in the table on
page 29.
To decrease the level or
turn off the loudness
To increase the level or
turn on the loudness
Indication pattern changes as
you adjust the bass or treble.
Ex. 1: When you adjust “TRE” (treble)
Ex. 2: When you turn on the loudness
VOL
(volume)
BAS
(bass)
TRE
(treble)
FAD
(fader)
BAL
(balance)
LOUD
(loudness)
EN29-30_KD-SC607[EE]f.p65 11/27/03, 12:19 PM30
To Next Page
Loading...
Need help?
General
