JVC GR-45 User Manual

8
Determine the focus and composition by re¬
ferring to the viewfinder image. For zooming,
see page 18.
For date/time recording, see page 16.
Press the start/stop button.
•This causes REC or LP REC to appear on the
viewfinder screen, showing that recording is
actually taking place.
• Be careful not to touch any buttons inadvertent¬
ly during shooting.
To stop recording temporarily, press the start/
stop button once again.
Quick Review function
• If you want to review the end of the last recording
for confirmation, press the QUICK REVIEW/
EDIT button from the Recording Standby mode;
the tape will be rewound for about 2 seconds for
program time and played back automatically for
this section, after which it will stop in the Record¬
ing Standby mode for the next shot.
To restart recording, press the start/stop button.
• For a long pause, press the POWER switch to
OFF to save battery power.
• If the Recording Standby mode continues for
longer than about 5 minutes, the unit switches
itself off automatically. To restart recording,
turn the power on and press the start/stop
button. This makes clean assembled recordings
possible even after a long pause.
Assemble recordings
• Repeating steps 9 and 11 produces assemble re¬
cordings.
• If recording is restarted from the Stop mode, a
few frames of the previously recorded picture is
replaced with a new recording. To avoid this, follow
the technique described in "Assemble Recording
Technique-2" on page 12.
To end recording, press the STOP button.
•After making sure that the tape has stopped,
press the POWER switch to OFF.
Notes:
•The TRACKING control should be at its center
position.
•Distortion might occur when playback starts. This
is normal.

JVC GR-45 Specifications

General

Brand	JVC
Model	GR-45
Category	Camcorder
Language	English