26 EN
Allows you to set the current date and time (Z pg. 7).
Allows you to set the tape length depending on the tape used (Z pg. 8).
This feature allows you to set the parameters for Animation and Time-Lapse
recording (Z pg. 33).
This feature allows you to set the parameters for Self-Timer (Z pg. 32) and Time-
Lapse recording (Z pg. 32, 33).
The tally lamp remains off at all times.
The tally lamp comes on to signal the start of recording.
This number is necessary when connecting the camcorder to a device such as a computer
using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting is 07.
Automatic demonstration will not take place.
Demonstrates certain functions such as Fade/Wipe, etc. When
“DEMO MODE” is set to “ON” and the Menu Screen is closed,
the demonstration starts.
NOTES:
●
When a tape whose Erase Protection tab is in the position that
allows recording is loaded in the camcorder, demonstration is
not available.
●
By turning off the camcorder or inserting a tape whose Erase
Protection tab is in the position that allows recording into it,
“DEMO MODE” is set to “OFF” automatically.
●
During the demonstration, all functions except zoom are
disabled.
OFF
ON
RECORDING
Advanced Features (cont.)
DATE/TIME
TAPE LENGTH
REC TIME
JLIP ID NO.
DEMO MODE
INT. TIME
TALLY LAMP
OFF
ON
Menu Screen Available Using The MENU Button (cont.)
: Factory-preset
To Next Page
Loading...
Need help?
General
