JVC GR-AX770 - Playback; Record-Standby; Still Playback

11
RECORDING
Set REC MODE, TAPE LENGTH and DATE/TIME
in SYSTEM MENU.
(
 pg. 18 – 22, “MENU SETTINGS”)
1 Remove the lens cap. Set the Power Switch 0
to “ ” or “ ”.
The camcorder enters the Record-Standby mode
and “PAUSE”
& is displayed.
2 Press the Recording Start/Stop Button 9. 6
appears while recording is in progress.
•To stop recording, press the Recording Start/Stop
Button
9. The camcorder re-enters the Record-
Standby mode.
PLAYBACK
1 Load a tape ( pg. 8, “Loading/Unloading A
Cassette”).
2 Set the Power Switch 0 to “ ”. To start
playback, press
4 /6 #.
To stop playback temporarily (Still Playback), press
4 /6 #. To stop playback, press 5 !. Press 2
@ to rewind, or 3 $ to fast-forward the tape.
High-speed picture search (Shuttle Search) is
possible by pressing
2 @ or 3 $ during
playback (holding
2 @ or 3 $ down during
playback continues search until released). To
resume normal playback, press
4 /6 #.
For VIDEO RECORDING/VIDEO PLAYBACK
•The camcorder shuts off automatically after about
5 minutes in the Record-Standby or Stop mode.
To turn or again, set the Power Switch
0 to
“OFF”, then to “
”, “ ” or “ ”.
•The playback picture can be viewed in the
viewfinder or a connected TV (
 pg. 15,
“Connections To A TV/VCR”).
•To remove the indications,
 pg. 21, DISPLAY or
OSD OUTPUT in SYSTEM MENU.