JVC GR-D350AG

EN 15
GETTING STARTED
MasterPage: Start_Right
GETTING STARTED
The date/time is recorded onto the tape at all
times, but its display can be turned on or off
during playback. ( pg. 25)
1 Perform steps 1 – 4 in “Language Settings”
on the left column.
2 Press 3 or 4 to select “CLOCK ADJ.”, and
press SET or 2. The date display format is
highlighted.
3 Press 3 or 4 to select the desired date
display format, then press SET or 2. Select from
“MONTH.DATE.YEAR”, “DATE.MONTH.YEAR”
or “YEAR.MONTH.DATE”.
4 Press 3 or 4 to select the time display
format, then press SET or 2. Select from “24h”
or “12h”.
5 Set the year, month, day, hour and minute.
Press 3 or 4 to select the value, then press SET
or 2. Repeat this step until you have input all the
settings.
NOTE:
Press 1 to return to the previous setting.
6 Press MENU.The Menu
screen closes.
1 Adjust the velcro strip.
2 Pass your right hand
through the loop and grasp
the grip.
3 Adjust your thumb and
fingers through the grip to
easily operate the
Recording Start/Stop
Button, Power Switch and
Power Zoom Lever. Be
sure to fasten the velcro strip to your preference.
1 Set the Power Switch to “REC” while pressing
down the Lock Button located on the switch.
2 Make sure the LCD monitor is closed and
locked. Pull out the viewfinder fully and adjust it
manually for best viewability.
3 Turn the Diopter Adjustment Control until the
indications in the viewfinder are clearly focused.
CAUTION:
When retracting the viewfinder, take care not to
pinch your fingers.
1 Set the Power Switch
to “REC” or “PLAY” while
pressing down the Lock
Button located on the
switch.
2 Open the LCD monitor
fully. ( pg. 17)
÷ To adjust the brightness of
the viewfinder, pull out the
viewfinder fully and set
“PRIORITY” to “FINDER”
( pg. 23, 24).
3 Press MENU. The
Menu Screen appears. If
you are in Playback mode,
please proceed to Step 5.
4 Press 3 or 4 to select “DISPLAY”, and press
SET or >. The DISPLAY Menu appears.
5 Press 3 or 4 to select “BRIGHT”, and press
SET or 2. The Menu Screen closes and the
brightness control indicator appears.
6 Press 3 or 4 until the appropriate brightness
is reached and press SET or 2.
7 Press MENU. The menu screen closes.
Date/Time Settings
Grip Adjustment
CLOCK AD J .
DISPLAY
MNTH
1
3:001
12006
24h
..
DATE YEAR..
O
Viewfinder Adjustment
Brightness Adjustment Of The
Display
Diopter Adjustment Control
Example:
–1BRIGHT
MENU
GR-D350AG_EN.book Page 15 Wednesday, December 28, 2005 8:24 AM