EN 23
VIDEO PLAYBACK
MasterPage: Start_Right
VIDEO RECORDING & PLAYBACK
A Yellow to VIDEO IN (Connect when your
TV/VCR has only A/V input connectors).
B Red to AUDIO R IN
C White to AUDIO L IN
1 Make sure all units are turned off.
2 Connect the camcorder to a TV or VCR as
shown in the illustration.
If using a VCR, go to step 3.
If not, go to step 4.
3 Connect the VCR output to the TV input,
referring to your VCR’s instruction manual.
4 Turn on the camcorder, the VCR and the TV.
5 Set the VCR to its AUX input mode, and set
the TV to its VIDEO mode.
6 Start playback on the camcorder. (墌 pg. 21)
● Please set “16:9 OUTPUT” of Playback Menus so
that the image may suit your TV (16:9 TV or 4:3
TV). (墌 pg. 17, 28)
To choose whether or not the following
displays appear on the connected TV
● Date/Time
Set “DATE/TIME” to “ON” or “OFF”.
(墌 pg. 28)
● Time Code
Set “TIME CODE” to “ON” or “OFF”. (墌 pg. 28)
● Indications other than date/time and time code
Set “ON SCREEN” to “OFF”, “LCD” or “LCD/TV”.
(墌 pg. 28)
NOTES:
● It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
(墌 pg. 14)
● To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder’s Power Switch to
“REC”, then set
your TV to the appropriate input mode.
● Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
Connections To A TV Or VCR
A
C
B
TV
VCR
Audio/Video
cable
(provided)
To AV
connector
or
To Next Page
Loading...
Need help?
General
