EN 49
ENGLISH
* The camcorder turns off automatically. Re-check if the indication clears. When it does, you can resume
using the camcorder. If the indication remains, consult your nearest JVC dealer.
Warning Indication Meaning / Remedy
● Displays the battery remaining power.
● As the battery power comes close to nil, the battery remaining power
indicator blinks. When the battery power is exhausted, power turns
off automatically.
SET TO MANUAL MODE
● Appears when you attempt to change “Menu Settings”, “Backlight
Compensation” or “Manual Focus” while in AUTO mode A (墌 22).
TAPE END
● Appears when the tape ends during recording or playback.
LENS CAP
● Appears for 5 seconds after power is turned on if the lens cap is
attached or when it is dark.
SET DATE/TIME!
● Appears when the date/time is not set (墌 19).
● The built-in clock battery has run out and the previously set date/time
has been erased. Consult your nearest JVC dealer for replacement.
● Appears if a tape is loaded while the Power Switch is set to
“REC”.
● Blinks when no tape is loaded.
CHECK TAPE’S ERASE
PROTECTION TAB
● Appears when the erase protection tab is set to “SAVE” while the
Power Switch is set to “REC”.
A. DUB ERROR!
<CANNOT DUB ON A LP
RECORDED TAPE>
<CANNOT DUB ON A
16BIT RECORDING>
<CHECK TAPE’S ERASE
PROTECTION TAB>
● Appears if Audio Dubbing is attempted on a blank portion of a tape
(墌 46).
● Appears if Audio Dubbing is attempted on a tape recorded in the LP
mode (墌 46).
● Appears if Audio Dubbing is attempted on a tape recorded in 16-BIT
audio (墌 46).
● Appears if A. DUB (
D) on the remote control is pressed when the
erase protection tab is set to “SAVE” (墌 46).
INSERT ERROR!
<CANNOT EDIT ON A LP
RECORDED TAPE>
<CHECK TAPE’S ERASE
PROTECTION TAB>
<CANNOT EDIT ON A
BLANK PORTION>
● Appears if Insert Editing is attempted on a tape recorded in the LP
mode (墌 46).
● Appears if INSERT (I) on the remote control is pressed when the
erase protection tab is set to “SAVE”. (墌 46)
● Appears if Insert Editing is attempted on a blank portion of a tape
(墌 46).
MEMORY IS FULL
● Appears when the memory card’s memory is full and shooting is not
possible.
UNIT IN SAFEGUARD
MODE
REMOVE AND
REATTACH BATTERY
OR DC PLUG
● Error indications (01, 02 or 06).
Remedy: Remove and reattach the power supply or battery*.
UNIT IN SAFEGUARD
MODE
EJECT AND REINSERT
TAPE
● Error indications 03 or 04.
Remedy: Eject the cassette and re-insert*.
High
Exhausted
GR-D860
GR-D860
GR-D860
Troubleshooting
GR-D820EK_GR-D860EK.book Page 49 Monday, November 19, 2007 10:15 AM
To Next Page
Loading...
Need help?
General
