EN
13
Memory card
Card Cover
Loading A Memory Card
The provided memory card is already inserted in the
camcorder when you receive the camcorder.
1 Make sure the camcorder’s power is off.
2 Open the card cover (MEMORY CARD).
3 Insert the memory card clipped edge first.
• Do not touch the terminal on the reverse side of the
label.
4 To close the card cover, push it until you hear a
click.
To Unload A Memory Card . . .
..... in step 3 push the memory card, which then
comes out of the camcorder automatically. Pull it
out and close the card cover.
NOTES:
● Be sure to use only SD Memory Cards marked
“
” or MultiMediaCards marked
“
”.
● Some brands of memory cards are not compatible with
this camcorder. Before purchasing a memory card ,
consult its manufacturer or dealer.
● Before using a new memory card, it is necessary to
FORMAT the card.
墌 pg. 51.
ATTENTION
Do not insert/remove the memory card while the
camcorder is turned on, as this may cause the
memory card to be corrupted or cause the camcorder
to become unable to recognize whether or not the
card is installed.
Clipped edge
Label
To Protect Valuable Files (available only for SD Memory Card) . . .
..... slide the write/erase protection tab on the side of the memory
card in the direction of “LOCK”. This prevents the memory card
from being recorded over. To record on this memory card, slide
the tab back to the position opposite to “LOCK” before loading it.
Write/erase
protection tab
To Next Page
Loading...
Need help?
General
