EN
45
SELECT SCENES
4 Point the remote control at the camcorder’s
remote sensor. Press PLAY (
4
) and then press ON/
OFF on the remote control.
The Random Assemble Editing Menu appears.
5 At the beginning of the scene, press IN/OUT on
the remote control. The Edit-In position appears in
the Random Assemble Editing Menu.
6 At the end of the scene, press IN/OUT. The Edit-
Out position appears in the Random Assemble
Editing Menu.
7 Repeat steps 5 and 6 to register additional
scenes.
• To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
NOTES:
● When choosing a scene, set Edit-In and Edit-Out points
so that there is a relatively large difference between
them.
● If the search time for an in-point exceeds 5 minutes, the
recording deck’s Record-Standby mode will be
canceled and editing will not take place.
● If there are blank portions before or after the Edit-In and
Edit-Out points, a blue screen may be included in the
edited version.
● Since time codes register time only as accurately as
seconds, the time code total time may not match the
total program time exactly.
● Turning off the camcorder’s power erases all registered
Edit-In and Edit-Out points.
1
2
3
4
5
6
7
8
––: –– ~
~
~
~
~
~
~
~
–
–
:
––
0
:
000
––
TOTAL
CODETIME
NIOUT
MODE
PLAY
CANCEL
REW
FF
ON/OFF
IN/OUT
Random Assemble
Editing Menu
Program
Remote sensor
RM-V700U
(optional)
CONTINUED ON NEXT PAGE
To Next Page
Loading...
Need help?
General
