EN
55
• This is a result of exceedingly high
contrast, and is not a malfunction.
• This is not a malfunction.
•“DATE/TIME” is set to “OFF” in the
Menu Screen.
•“TIME CODE” is set to “OFF” in the
Menu Screen.
• In places subject to low tempera-
ture, images become dark due to
the characteristics of the LCD
monitor. When this happens, the
displayed colors differ from those
that are actually recorded. This is
not a defect of the camcorder.
• When the LCD monitor's fluores-
cent light reaches the end of its
service life, images on the LCD
monitor become dark. Consult your
nearest JVC dealer.
• The light used to illuminate the LCD
monitor causes it to become hot.
• This may occur when the surface or
the edge of the LCD monitor is
pressed.
————
————
• Set “DATE/TIME” to “ON” in the
Menu Screen (墌 pg. 35).
• Set “TIME CODE” to “ON” in the
Menu Screen (墌 pg. 35, 36).
• Adjust the brightness and angle of
the LCD monitor (墌 pg. 15, 16).
• Close the LCD monitor to turn it off
or set the Power Switch to “OFF”,
and let the unit cool down.
————
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
% When shooting a subject
illuminated by bright light,
vertical lines appear.
^ When the screen is under
direct sunlight during
shooting, the screen
becomes red or black for an
instant.
& During recording, the date/
time does not appear.
* Time code does not appear.
( Images on the LCD monitor
appear dark or whitish.
) The rear of the LCD monitor
is hot.
q The indicators and the
image color on the LCD
monitor are not clear.
CONTINUED ON NEXT PAGE
To Next Page
Loading...
Need help?
General
