EasyManua.ls Logo

JVC GR-DVL820

JVC GR-DVL820
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
40
EN
IMPORTANT
Some Fade/Wipe Effects cannot be used with certain
modes of Programme AE with special effects
(Z pg. 38, 39). If an unusable Fade/Wipe Effect is
selected, its indicator blinks or goes out.
Fade/Wipe Effects
These effects let you make pro-style scene transi-
tions. Use them to spice up the transition from one
scene to the next.
Fade or Wipe works when tape recording is started
or when you stop recording.
1 Set the VIDEO/MEMORY Switch to “VIDEO”
(GR-DVL1020/DVL820/DVL520 only), then set the
Power Switch to “
MANUAL
” while pressing down the
Lock Button located on the switch.
2 Press the MENU/BRIGHT wheel in. The Menu
Screen appears.
3 Rotate the MENU/BRIGHT wheel to select “
WIPE/FADER”, then press it.
4 Rotate the MENU/BRIGHT wheel to select the
desired function, then press it. Selection is complete.
Press the MENU/BRIGHT wheel in again.
The WIPE/FADER Menu disappears and the effect
is reserved. The indicator representing the selected
effect appears.
5 Press the Recording Start/Stop Button to activate
the Fade-in/out or Wipe-in/out.
To Deactivate The Selected Effect . . .
..... select “OFF” in step 4.
NOTE:
You can extend the length of a Fade or Wipe by pressing
and holding the Recording Start/Stop Button.
FOR RECORDING
(cont.)
Recording Start/Stop Button
MENU/BRIGHT Wheel
Power Switch
VIDEO/MEMORY Switch
(GR-DVL1020/DVL820/DVL520
only; open the LCD monitor to
access this switch.)
Lock Button

Table of Contents

Related product manuals