76 EN
TROUBLESHOOTING
(cont.)
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
35.
The LCD monitor image is
distorted.
36.
Images on the LCD monitor
are jittery.
37.
There is no playback picture
on the connected TV.
38.
Blocks of noise appear
during playback, or there is
no playback picture and the
screen becomes blue.
39.
The LCD monitor, the
viewfinder and the lens have
become dirty (ex. finger-
prints).
40.
An unusual mark appears.
41.
An error indication
(E01 — E06) appears.
42.
The charger indicator on the
camcorder does not light.
43.
When the image is printed
from the printer, a black bar
appears at the bottom of the
screen.
44.
When the camcorder is
connected via the DV
connector, the camcorder
does not operate.
45.
The memory card cannot be
removed from the
camcorder.
35.
• During playback of the
unrecorded portion, High-
speed Search and still
playback, LCD monitor
indications appear distorted.
This is not a defect.
36.
• The speaker volume is too
great.
37.
• Since the analogue input mode
is engaged, the camcorder is in
the Record-Standby mode.
38.
————
39.
————
40.
————
41.
• A malfunction of some kind
has occurred. In this case the
camcorder’s functions
become unusable.
42.
• The temperature of the battery
is extremely high/low.
• Charging is difficult in places
subject to extremely high/low
temperatures.
43.
• This is not a malfunction.
44.
• The DV cable was plugged/
unplugged with power turned
on.
45.
————
35.
————
36.
• Turn the speaker volume
down ( pg. 21).
37.
• Set “S/AV INPUT” to “OFF” in
the Menu Screen ( pg. 50).
38.
• Clean the video heads with an
optional cleaning cassette
( pg. 86).
39.
• Wipe them gently with soft
cloth. Wiping strongly can
cause damage ( pg. 77).
40.
• Check the section of the
manual that explains LCD
monitor/viewfinder indica-
tions ( pg. 80 – 84).
41.
• Remove the power supply
(battery pack, etc.) and wait a
few minutes for the indication
to clear. When it does, you
can resume using the
camcorder.
If the indication remains even
though you repeat the above
two or three times, please
consult your nearest JVC
dealer.
42.
• To protect the battery, it is
recommended to charge it in
places with a temperature of
10°C to 35°C ( pg. 85).
43.
• By recording with “DIS”
activated ( pg. 47) this can
be avoided.
44.
• Turn the camcorder’s power
off and on again, then operate
it.
45.
• Push in the memory card a
few more times ( pg. 14).
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General
