EN19
NOTES:
●
To remove the shutter sound,
Z
“BEEP/TALLY” on
pg. 31.
●
If Digital Zoom is used while in the “MULTI-4” or
“MULTI-9” mode, Snapshot recording will be performed
with 10X magnification.
●
In Multi-Analyser 4 or Multi-Analyser 9, the flash is
disabled (
Z
pg. 34).
●
If Snapshot recording is not possible, “PHOTO” blinks
when SNAPSHOT is pressed.
●
If Programme AE with special effects (
Z
pg. 40) is
engaged, certain modes of Programme AE with special
effects are disabled during Snapshot recording. In such a
case, the icon blinks.
●
If SNAPSHOT is pressed when “DIS” is set to “ON”
(
Z
pg. 32), the Stabiliser will be disabled.
●
To dub images recorded on a tape to a MultiMediaCard,
Z
pg. 67.
●
The flash is disabled during video recording.
●
To reduce the Red-Eye effect in the subject’s eyes when
the flash fires,
Z
pg. 34.
●
During playback as well, all snapshot modes except
Nega/Posi mode are available when “ COPY”
is set to “OFF” in the VIDEO MENU (
Z
pg. 46).
●
When a headphone set is connected to the PHONE
connector, the shutter sound is not heard from the
speaker, however it is recorded onto the tape.
Snapshot Search
Lets you find snapshots during playback of a tape.
1
Play back the tape (Z pg. 44).
2
Press INDEX SCREEN. “SNAPSHOT SEARCH”
appears blinking on the screen and the tape fast-
forwards and pauses at a snapshot. When pressed
again, the tape pauses at the next snapshot. Repeat
until the desired snapshots are found.
MULTI-9
Multi-Analyser 9
FULL
Snapshot mode
with no frame*
√
PIN-UP
Pin-Up mode
√
FRAME
Snapshot mode
with frame*
√
MULTI-4
Multi-Analyser 4
* There is the sound effect of a shutter closing.
√
When the Shooting Mode Dial is set to “PS”,
snapshot recording will be performed with higher
quality (
Z pg. 24).
NEGA/POSI
Nega/Posi mode*
√
To Next Page
Loading...
Need help?
General
