EasyManua.ls Logo

JVC GR-DVM70 - Page 109

JVC GR-DVM70
112 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DeclarationofConformity
Mode[ Number : CU-VS01U
Trade Name : JVC
Responsible party : US JVC CORR
Address : 17(30 Valley Road Wayne,
N. I. 07470
Telephone Number : 973-315 5000
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and (2) this device must accept
any interference received, including interfer-
ence that may cause undesired operation.
Change (it modifications not approved by tile
party responsible for compliance could void the
user's authority to operate the equipment. This
equipment has been tested and found to
c(_mply with the limits for a ([lass B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and car/radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which car/be
determined by turning the equipment off and
on, the user is encouraged to try to correct tile
interference by one or more of tile following
i_/eastlres:
Reorient or relocate the receiving antenna.
Increase the separation between the equip-
merit and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/
TV technician for help.
About moisture condensation...
You have observed that pouring a cold liquid
into a glass will cause drops of water to form
on the glass' outer surface. This same
phenomenon occurs on the head drum of a
camcorder when it is moved from a cool
[)lace to a warm place, after heating a cold
room, under extremely humid conditions or
in a place directly subjected to the cool air
from an air conditioner.
Moisture on tile head drum car/cause severe
damage to the vide() tape, and can lead to
internal damage to the camcorder itself.
Serious malfunctioning
If malfunctioning occurs, st()[) using tile unit
immediately and consuh your local JVC dealer.
Tile camcorder is a microcomputer-controlled
device. External noise and interference (from a
TV, a radio, etc.) might prevent it from function-
ing properly. Ill such cases, first disconnect its
power supply unit (battery pacl<, AC Power
AdaptetTBattery ( harger, etc.) and wait a few
minutes and then re-connect it and proceed as
usual from the beginning.

Related product manuals