ENI 1
ATTENTION:
Before detadling the power source,
make sure that the camcorder's power
is turned off. Failure to do so can result
in a camcorder malfunction.
USING TIlE BATTERY PACK
ATTACH BATTERY PACK
Insert tile terminal end _ of tile battery packJilt() tile
battery pack mount, then firmly push the end _2_of
the battery pacl< in the direction of the arrow until it
locks into place as shown in the illustration.
° If the battery pacl< is attached in the wrong position,
a malfunction may occur.
To Detach The Battery Pack,..
.... while sliding down BAT]-. RELEASE, detach it.
NOTES:
• Continu_xls shooting is p_ssibl_ when the t_mperatur_ is
appr_x, 20 _(/68 _1.
• However, c_mtinuous shooting capability is reduced
sigrlificarttly under the f_>lh>wing conditiorls:
° The temperature is below l O°(7_O_F.
° Zoom or Record-Standby mode is engaged repeatedly.
° The LCD monitor is used repeatedl)<
Before extended use, it is recommended that you
prepare enough battery pacl<_ to cover _times the
planned shooting time,
Approximate recording time
Batterypack [CD monltor on/
Viewfinder off
BN-V507U 55 rain.
BN-V514U I 15 rain.
BN-Vt156U 7 hrs. 30 rain.
LCD monitor off/
Viewfinder on
65 rain.
130 rain.
8 hrs. 30 Illill.
To AC outlet
AC Power
Adapter/Charger
AA-V_OU
Power cord
terminal
DC cord
INFORMATION:
VU-V8S6I<IT is a set composed _i the BN-V8_6 U battery
pack and AA- V80U A C Power Adapter/(harger.
Also read thor_mghly the VU- VSF6KIT's instruction
I7)al-luals,
It is impossible to charge the BN- V856U battery pack
using the pr_)vided AC P_>wer Adapter/(harge_ Use the
optiona I AA- V80U AC P¢;wer Adaptdt/Charger.
USING AC POWER
Use the AC Power Adal>ter/( harger (connect as shown ill
the illustration).
NOTES:
• The proviclecl AC Power Adapter/Charger i_atures
automatic vohage selection in the AC range tr_m) 110 V
to 240 V.
• For other notes, _ z_pg. 10.
To battery
pack mount
To Next Page
Loading...
Need help?
General
