START/STOP Button
Tape remaining time indicator
I
f
3 min
!
2 min
(Blinking)
1 min
(Blinking/
!
0 min
/Blinking/
STOP RECORDING
Press START/STOP again to stop recording.
• The camcorder re-enters the Record-Standby male.
NOTES:
• The image will not appear simultane(_usly in the LCD
monit_r and the viewfinde_ No image appear_ on the
LCD monitor when the viewfincbr is pulled out. It is riot
possible to shoot usin_ both LCD monitor and
viewfirlde_
• The cassette holder carlrlot be opened unless a power
supply is attached.
• There may be a d_by after y_*u _*pen the cassette cover
urltil the holder (*pens. Do not use force.
•_ The indicated tape remaining time is approximate.
• The time required t_*cakulate arid to dispby the
remaining tape length, and the accuracy ot the calcula-
tiorl, may vary accordirlg to the type ot tape used.
• "TAPE END" appear_ when the tape reaches its end, arid
the power goes off automatical/y if left in this condition
for 5 mir_utes. "TAPE END" al_o appear_ wher_ a cassette
whose tape is already at its erld is k_aded.
• If the Record-Starlrlby mode corltirlues for 5 mirlutes, the
camcorder'_ power shuts off automatically. To turn the
camcorder on again, push back and pull out the
viewfincter again or close and re-open the LCD monito_
• When a blank portion is loft between recorded scenes
on the tape, the time c_;de is interrupted and em;r_ may
occur when editing the tape. Corltinue recording from
where you stop so that there are no gaps by following
"Recording t?om the mirldle ota tape" (_Z _ P_4.27).
• During, recording, sourld is not heard from the _peaker. If
you warlt to hear the sound, connect optiorlal heat%
phones to the headphones connectoll The sotll-}d
volume at this point is the same as the level it was
adjusted during playback.
•_ To turn the tally lamp offduring recording; refer to
pgs. _6 30.
To Next Page
Loading...
